1.On the Settings tab, click System, and then click SpeedLine Connect. 
|
Note These steps only have to be completed when setting up SpeedLine Connect for the first time. If Connect is already active, skip to the next step in the tutorial. |
2.On the General tab, select the Active check box.
3.Clear Allow Training Mode on Processing Station, unless you want to make training mode available on the station that processes orders (usually your primary station).
|
Caution Allowing training mode on the processing station is not recommended, as it will interfere with the processing of incoming remote orders. |
4.Ensure store hours have been entered:
a.In the side menu, click Store Information. 
b.Click the Hours tab and ensure the hours shown are correct.
Add a 3rd Party Connect Source SpeedStart Tutorial 
Using SpeedDine instead of a third-party source? See the Add a SpeedDine Source SpeedStart Tutorial.
•Add an Connect Source Tutorial Home
You are here 
Step 1: Activate SpeedLine Connect
•Step 2: Set Connect Source General Properties
•Step 3: Set Connect Source Restrictions
•Step 4: Set Connect Source Connection
•Step 5: Generate or Load a Local Source Certificate
•Step 6: Generate the External Source Certificate
