1.On the Settings tab, click System, and then click SpeedLine Connect. 
|
Note These steps only have to be completed when setting up SpeedDine for the first time. If Connect is already active, skip to the next step in the tutorial. |
2.On the General tab at the top, select the Active check box.
3.Clear Allow Training Mode on Processing Station, unless you want to make training mode available on the station that processes orders (usually your primary station).
|
Caution Allowing training mode on the processing station is not recommended, as it will interfere with the processing of incoming remote orders. |
This topic is part of the Add a SpeedDine Source SpeedStart Tutorial 
Using a 3rd party source instead of SpeedDine? See the Add a 3rd Party Connect Source SpeedStart Tutorial.
You are here 
Step 1: Activate Connect
•Step 2: Set Connect Source General Properties
•Step 3: Set Connect Source Restrictions
•Step 4: Enter SpeedDine Connection Settings
